Average Type - Keysight FieldFox B Series User Manual

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
SA Mode Settings
A color-coded legend for displayed traces is visible in the left pane of the SA
mode screen:
W = Clear/Write; M = MaxHold; m = MinHold; A = Average; V = View
How to display the Trace States
1. Press Trace 6.
2. Then
3. Then
4. Then choose from the following Trace States:
5. Press
Trace 4 data WILL be overwritten by the FieldFox when using the
Independent Source Normalize feature
Generator " on page
corrections

Average Type

In SA Mode, there are four different processes in which Averaging is performed:
— Average Traces – Learn more in
— Detection Method Averaging – Learn more in
202
Trace 1,2,3,4 repeatedly to select a trace number to display or
change its state. Traces are displayed in the following colors:
— Trace 1 – Yellow
— Trace 3 – Orange
State [current setting]
— Clr /Wr (Clear/Write) Displays the actual measured data for each
sweep.
— MaxHold Displays the maximum response of the input signal at each
data point over multiple sweeps. See also Average Count in
"Average Count" on page
— MinHold Displays the minimum response of the input signal at each
data point over multiple sweeps. See also Average Count in
"Average Count" on page
— Average Each data point is averaged over multiple sweeps as set by
the Average Count setting. Learn more in
page 203.
— View Displays and then holds the last complete measurement trace
on the screen. This is similar to storing a trace in memory.
— Blank Displays no trace.
Default All to return all traces to their default settings: Trace 1
(Clear/Write); all other traces (Blank).
184) or using Field Strength antenna or cable
("Field Strength Measurements" on page
page 211.
Trace 2 – Blue
Trace 4 – Green
203.
203.
"Average Count" on
("Independent Source/Tracking
"Averaging" on page
"Detection Method" on
Keysight N9938-90006 User's Guide
161).
218.