Keysight FieldFox B Series User Manual page 360

Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5G TF
Option 377, 5G NR / 5G NR EVM Conducted Option 378
How to Set Up Over–the–Air (OTA) Mode Settings
2. Selecting OTA mode:
3. Selecting an OTA format:
4. Define some carrier and cell measurement information. See also,
If after making the setting changes in the steps below, no data is
displayed, refer to
Display does not update (refresh), until all active component carriers (CCs)
have been scanned.
5. Press Freq/Dist
360
— See also "GNSS (GPS+) and GPS" on page
— Press Mode_.
— Then More (may not be available—number of installed options
dependent)
— Then OTA.
Press Measure – (When you initially select OTA mode, the FieldFox
defaults to the Measure menu.)
— The Measure menu is used to select an OTA format (e.g., Option 370
LTE FDD, Option 371 LTE TDD, Option 377 5G TF, etcetera):
(Available modes are Option dependent.)
— LTE FDD
— LTE TDD
— 5G TF
— 5G NR
— 5G NR EVM Conducted
The OTA format chosen begins scanning for signals.
Additional FieldFox setting changes are required for OTA to
display the available signals. Refer to the steps below and
see also,
page 378.
Define a Cell or Cell(s) and Use
Then modify the carrier and cells based on the selected OTA technology
(i.e., LTE FDD, LTE TDD, 5G TF, and 5G NR /5G NR EVM Conducted).
"Troubleshooting" on page
— Then CC CC0 (Default is CC0) – Selects the CC number to be
displayed (LTE FDD/LTE TDD choices: CC0-CC4, 5G NR Choices:
CC0-CC7). If only one CC is selected, the FieldFox will not allow you
to disable the scan. See also, the Trace hardkey in step 7.
(default) or
"How to Define a Cell or Cell(s) and Use OTA" on
OTA".
410.
Keysight N9938-90006 User's Guide
784.
"How to