Keysight FieldFox B Series User Manual page 511

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
How to Use Data Logging (Option 352)
During recording, choose from the following:
—
—
To change Data Logging Configuration settings:
— Press Trace 6
— Then
— Then
— Then
Learn more, refer to the
How to Play a Data Log
— Press Trace 6
— If the session is already open, skip the following step. Otherwise:
Keysight N9938-90006 User's Guide
is displayed in the left of screen graticules.
Pause Resume Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue recording.
Stop Immediately stops recording. Then choose from the following:
— Then Record Save/Recall
change your file settings. Learn more, refer to
Logging Configuration settings:" on page
——Press Save Log File
save device is Internal).
— Then Record Settings
measurement interval settings. Learn more, refer to
Logging Configuration settings:" on page
Data Logging then choose:
Record Settings
— Optional: Then Meas Interval
——Then Interval Type
——Then, if applicable
Or
——Then, if applicable
miters.
Record Save/Recall
— Then Device (Internal (default), SD Card, or USB)
— Then File Type (CSV (default), DREC (Option 360 Only), or KML)
Chapter 32, "File
To save a log file, recall a log file, or
to save the current Table data (i.e., default
(Outdoor Mapping only) To change your
(Outdoor Mapping only)
> ON
> choose Time or Distance.
Time Interval
Distance Interval
Management".
"To change Data
511.
"To change Data
511.
enter time interval in seconds.
enter distance interval in
511