Keysight FieldFox B Series User Manual page 795

System Settings
System Configuration
— Static IP Address - Enter the IP Address – including periods - in the format
For all FieldFoxes with firmware ≤A.08.18 and ≤A.09.50 FW, when using
Static IP addresses:
– Either a valid Static Gateway is required or 0.0.0.0.
– Either a valid Static DNS is required or 0.0.0.0. (If entry is available.)
— Static Subnet Mask - Enter the Subnet Mask – including periods - in the
— Static Gateway - Enter the Static Gateway – including periods - in the
— Static DNS - Enter the Static DNS – including periods - in the format
— Apply Settings Choose from:
To make the LAN settings persist after power up, toggle Apply Settings to
Now then back to Power Up. You should see a message indicating that the
LAN config file was saved.
3. Press
Power ON
When the FieldFox is without a power source, this setting allows the FieldFox
to power ON when the DC Adapter is inserted without pressing the power
button.
How to set Power ON
1. Press System 7 >
2. Then choose from the following:
Keysight N9938-90006 User's Guide
nnn.nnn.nnn.nnn
format nnn.nnn.nnn.nnn
format nnn.nnn.nnn.nnn
nnn.nnn.nnn.nnn
— Power Up The above settings take effect when the FieldFox is
started.
— Now The above settings take effect immediately.
Done Edit when finished.
System Configuration
— Auto The FieldFox will power ON when the DC Adapter is inserted.
— Manual The FieldFox will power ON only when the power button is
pressed.
More Power ON
> >
795