Points; Trace Display States (Emi Mode) - Keysight FieldFox B Series User Manual

Electromagnetic Interference (EMI) Measurements – Option 361
EMI Measurements Mode Settings

Points

In the EMI measurements mode, the Points softkey is only active when the
Measurement CISPR softkey is set to Fast SA Scan. Otherwise EMI mode
automatically sets the points (Default = 401). Learn more, see
then

Trace Display States (EMI Mode)

For EMI measurements mode, this section defines the four trace state
choices for the Fast SA Scan and for CISPR Band Scan, CISPR Zoom Scan,
and APD Statistics choices. Also, this section defines the 4th trace display
state choices. Learn more, see
The behavior of EMI mode is similar to SA mode. This section describes the
softkeys that have similar, but also different behaviors than SA mode. Learn
more, refer to
Analyzers).". See also
How to display the Trace States
— Press Trace 6 >
How to set the EMI Traces
When the EMI measurement type is set to CISPR Band Scan or CISPR Zoom
Scan Trace 1, Trace 2, Trace 3 have default values assigned. The trace can be
disabled under the Measure 1 (toggle to enable/disable) or the Trace 6
332
— Dwell /Point (Active when the CISPR Measurement type == CISPR
Band Scan or CISPR Zoom Scan.) Specifies a settling time (in
seconds) between sweeps.
— SwpAcquisition
number of sweep acquisitions. Press manual to enter a sweep
acquisition value. (Default = Auto). Learn more, see
then "Sweep Acquisition" on page
— APD Dwell Time
APD Statistics.) Sets the time to acquire statistics each cycle, and
Trace Points (control grayed out) are derived from the total Amplitude
range displayed on the X axis.
"Points " on page 201.
Chapter 9, "SA (Spectrum Analyzer) Mode (Option 233–Mixed
"Marker Trace (IQA and SA Mode)" on page
Default All
their default settings. For EMI mode the defaults are: Trace 1 (PosPeak T1),
Trace 2 (QuasiPeak T2), Trace 3 (EMI Average T3); Trace 4 (Off, but defaults
to Pos Peak).
– (Active only for Fast SA Scan) Specifies a the
191.
– (Active only when the CISPR Measurement type =
"How to set the EMI Traces" on page
is measurement specific and returns all traces to
Keysight N9938-90006 User's Guide
Chapter 9 and
Chapter 9 and
332.
730.