Keysight FieldFox B Series User Manual page 617

ERTA (Extended Range Transmission Analysis) Mode - Option 209
Start Connection Wizard
STEP 3: Select LAN address of ERTA Partner
The Receiver unit is the primary partner, annotated with RCVR Primary.
The Source unit is the secondary partner, annotated with SRC Secondary.
On the Receiver unit:
— Press
— Press Continue.
STEP 4: Test Partnership
— Press
— If either the LAN or Trigger test fails, then press
— Optional: Press
— Press
— Select Global or Mode Preset
— Change Modes
— Recalling a non-ERTA State file. Recalling an ERTA State file can
Keysight N9938-90006 User's Guide
— On the Source unit, connect the Port 1 RF Output connector to the
input of a power splitter.
— Connect one power splitter output to the Source unit Port 2 RF Input.
— Connect the other power splitter output to the DUT input.
— Connect the DUT output to the Port 2 RF Input of the Receiver unit.
Simplified method (not shown):
— Omit the power splitter. Connect the Source unit Port 1 RF Output
connector to the DUT input. The measurement is a raw B receiver.
Specs do NOT apply.
ERTA Partner (not
units are displayed. Select the IP address of the Source unit. If 10.10.10.1
appears, then NO FieldFox units were found. The LAN setting "Obtain IP
Address using" MUST be set to DCHP. Learn more in
page 793. Also be sure that Opt. 209 has been installed correctly on the
Source unit.
Test Partnership. If the Source unit is NOT already in ERTA mode, it
will be started, which may take a several seconds. When successful, LAN
OK and Trigger OK will appear on the screen.
Partnership to retry the test.
Send Text
Receiver unit. A LAN connection is necessary. For quick communication,
custom Keywords can be setup using the FieldFox labeler. Learn how in
"Edit Keywords" on page
Any of the following will end the partnership:
EXIT Partnership
re-establish a partnership if the Source unit is still on the network at the
same location.
specified). The IP addresses of potential FieldFox
Message, then enter a message to send to the
815.
"LAN Settings" on
Clear Test, then Test
617