Keysight FieldFox B Series User Manual page 508

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
How to Use Data Logging (Option 352)
— Then
— Then
508
— Press Line Length
length of the line of bearing to extend it far enough to allow other
points to cross, indicating a possible emitter location.
— Press Accept Point
and returns to the previous menu.
Edit Points – Opens up menu of bearing point editing softkeys.
Choose from:
— Press Select Point
directly enter a new angle or line length or use the
the rotary knob to edit these values.
— Press Direction Line OFF ON
(default = OFF).
— Press Adjust Angle
Rotate the line about the current point (your current location) to point
towards the highest signal strength seen by your directional antenna.
You can rotate the knob to rotate the line, or you can type an angle
into the active entry directly.
— Press Adjust Angle
length of the line of bearing to extend it far enough to allow other
points to cross, indicating a possible emitter location.
— Delete Point – deletes the currently selected point.
Clear Points – Deletes all of the displayed bearing points and lines.
– Enters a value for the line's length. Adjusts the
or Back – verifies the new point is to be added
– Enter the point you want to edit. Then you can
– Enables/disables the direction line
– Enters the angle of the current point's line.
– Enters a value for the line's length. Adjusts the
Keysight N9938-90006 User's Guide
arrows, or