Keysight FieldFox B Series User Manual page 626

AM/FM Metrics (SA Only and Option 355)
Using AM/FM Metrics
How to Set Up AM/FM Metrics
— Connect a test tone to the FieldFox SA Port 2 (Port 2)
— Press Measure >
Selecting FM Wide vs. FM Narrow does not effect the displayed waveforms
or metrics. But, if you are using the Audio Demod feature and listening to
the demodulated waveform, then select the appropriate FM type, because
the tones do differ based on the FM type selected. Refer to
page
See also,
Analyzers)"
— Then Freq/Dist
— Set
— Optionally, adjust the
— Optionally, Freq/Dist >
626
Analog Demod Tune & Listen
624.
Chapter 9, "SA (Spectrum Analyzer) Mode (Option 233–Mixed
and to "Analog Demod" on page
Left display - Frequency Spectrum (Power vs. Frequency)
Right display - Demodulated waveform vs. time where
the width of the demod window.
>
Center
Freq Span so that all sidebands above -60 dB are displayed in the left
window.
AF Res BW
bands. Learn more, refer to
(Option 233–Mixed Analyzers)"
Resolution BW)" on page
demod softkeys. Tune & Listen can be set when you are in Analog
Demodulation mode, so you can enable Tune & Listen sweeps in between
your Analog Demod sweeps. To learn more about the Tune & Listen softkey
menu choices, refer to
Metrics are displayed in the AM/FM Modulation Metrics table on the
FieldFox. For AM and FM Metrics examples, refer to
Figure 27-8 on page 635.
172.
to set the carrier frequency.
to better identify audio frequency side
Chapter 9, "SA (Spectrum Analyzer) Mode
and "AF RBW (Audio-Frequency
186.
Tune & Listen OFF – Opens a menu of Tune & Listen
"Tune & Listen (AM/FM)" on page
Keysight N9938-90006 User's Guide
> Analog Demod
Table 27-1 on
Demod SwpT sets
168.
Figure 27-1 through