Table of Contents
Advertisement
NA (Network Analyzer) Mode
NA Mode Settings
— Then Settings.
— Press
— To change a setting:
— Press
Calibration Settings
NA Mode has a page specifically for making settings that pertain to Port
Extensions, including Velocity Factor and Media Type.
Learn more in
Learn more about Media Type in
How to view and change Calibration Settings
— Press Meas Setup 4.
— Then
— Make these settings in the same manner as Quick Settings in the previous
Keysight N9927-90001 User's Guide
Next Page
and
Previous Page
are NOT available, then all available settings fit on one page.
—Use the
arrows to highlight a setting.
—Then press Edit. The current setting changes to yellow.
—Some settings require you to press a softkey to change the value.
Otherwise, use the numeric keypad,
change the value.
—When finished changing a value, press
Dock Window
to relocate the Settings table to a position relative to
the trace window. The Dock Window setting persists through a Preset.
Choose from the following:
—Full (Default setting) Only the Settings table is shown on the screen.
The trace window is temporarily not shown.
—Left The Settings table is shown to the left of the trace window.
—Bottom The Settings table is shown below the trace window.
When finished changing ALL settings, press
"Port Extensions" on page
Calibration Settings
section.
to view all settings. If these softkeys
arrows, or rotary knob to
Done
Edit.
Done
to save your settings.
101.
"Waveguide Calibrations" on page
135.
91
Advertisement
Chapters
Table of Contents
