Table of Contents
Advertisement
Measure Microarray
Measures the concentration of purified
nucleic acids that have been labeled with
up to two fluorescent dyes for use in
downstream microarray applications.
Measure Microarray Samples
Reported Results
Settings
Detection Limits
Calculations
Measure Microarray Samples
To measure microarray samples
Thermo Scientific
Use the Microarray application to quantify nucleic acids that have been labeled with
up to two fluorescent dyes. The application reports nucleic acid concentration, an
A260/A280 ratio and the concentrations and measured absorbance values of the
dye(s), allowing detection of dye concentrations as low as 0.2 picomole per
microliter.
NOTICE
• Do not use a squirt or spray bottle on or near the instrument as liquids will
flow into the instrument and may cause permanent damage.
• Do not use hydrofluoric acid (HF) on the pedestals. Fluoride ions will
permanently damage the quartz fiber optic cables.
Before you begin...
Before taking pedestal measurements with the NanoDrop One instrument, lift the
instrument arm and clean the upper and lower pedestals. At a minimum, wipe the
pedestals with a new laboratory wipe. For more information, see
Pedestals.
4
Nucleic Acid Applications
Measure Microarray
Cleaning the
NanoDrop One User Guide
33
Advertisement
Table of Contents
