Table of Contents
Advertisement
Measure Kinetics
Measure Kinetics
To make kinetic measurements
Thermo Scientific
Make time-based kinetic measurements
using the cuvette holder (NanoDrop
C
One
model instruments only).
Measure Kinetics
Create Kinetics Method
Edit Kinetics Method
Reported Results
Settings
Detection Limits
C
The NanoDrop One
model instrument can be used to make time-based kinetic
measurements on samples in cuvettes. Up to 3 wavelengths between 190 nm and
850 nm can be designated for continuous absorbance monitoring at user-defined
intervals in up to 5 stages. Cuvette measurements offer an extended lower
limit
and an optional 37 °C heater and micro-stirrer.
Note The instrument arm can be up during cuvette measurements, which
allows you to add reagents to the sample solution if desired.
NOTICE
• To prevent damage from spills, keep containers of liquids away from the
instrument.
• Do not use a squirt or spray bottle on or near the instrument as liquids will
flow into the instrument and may cause permanent damage.
NanoDrop One User Guide
8
detection
169
Advertisement
Table of Contents
