Thermo Scientific NanoDrop One User Manual page 174

8 Measure Kinetics
172 NanoDrop One User Guide
If Heat Cuvette to 37 °C is selected in
you the current temperature and waits for the heater to reach the target
temperature before starting the measurements:
– Wait for blank measurement to complete and then remove cuvette
Note: The heater target temperature is not adjustable.
6. Measure a sample:
– Fill clean, dry cuvette with enough sample solution to cover
– Insert sample cuvette into cuvette holder, making sure to align light paths
– Tap Measure
If Heat Cuvette to 37 °C is selected in
you the current temperature and waits for the heater to reach the target
temperature before starting the measurements:
Note: You may add reagents to the sample solution at any time during the
measurement
Use the Pause button at the bottom of the measurement screen to pause
the experiment (if you need to end the experiment early, tap Stop)
– Wait for all measurement stages to complete
– Remove cuvette and clean it according to manufacturer specifications
Results for each measurement in each interval are displayed in real time. When
all stages are completed, the
experiment are displayed.
7. When you are finished reviewing the data, tap End Experiment. Each saved
experiment contains one complete set of kinetic measurements based on the
selected method.
General
To override the wait
and start the blank
measurement
immediately, tap
Blank Now.
General
spectra and reported values
Settings, a message tells
optical path
Settings, a message tells
for the entire
Thermo Scientific