Table of Contents
Advertisement
9
Learning Center
Instrument Settings
General Settings
242
NanoDrop One User Guide
Use this tab to specify one or more network paths for exporting acquired data when
an Ethernet cable is used to connect the instrument to an active network wall jack.
Network paths defined here will appear in the Export Data list box when exporting
data, from both the
History
measurement.
These options are available:
Auto-naming
Assign sample names automatically using base name
followed by unique number starting with "1." Uses default
("Sample") or user-specified base name. For details, see
Sample
Use cuvette
Select cuvette sampling mode. When selected, these
additional options are available:
Pathlength: Enter cuvette
blank or sample measurements with cuvettes (see cuvette
manufacturer for cuvette specifications)
Stir Speed: If using automatic stirring, drop micro-stir bead
into sample cuvette and set Stir Speed (levels 1 through 9
correspond with range from 10 RPM to 850 RPM with
controlled ramping from zero)
Heat cuvette to 37 °C: Select this option if sample
cuvettes require heating. Cuvette heater increases from room
temperature to 37 °C at rate of 5 °C/minute.
and the
End Experiment box
Name.
pathlength
after you complete a
(width) before taking
Thermo Scientific
Advertisement
Table of Contents
