Figure 10. Op Code Fetch (With Wait State) Timing Diagram - ZiLOG Z8018 Series User Manual

Mpu
Table of Contents

Advertisement

Z8018x
Family MPU User Manual
20
UM005004-0918
T1
Phi
A0
A19
D0
D7
WAIT
M1
MREQ
RD
Figure 10.
Op Code Fetch (with Wait State) Timing Diagram
Operand and Data Read/Write Timing
The instruction operand and data read/write timing differs from Op Code
fetch timing in two ways:
The M1 output is held inactive
The read cycle timing is relaxed by one-half clock cycle because data
is latched at the falling edge of T3
Instruction operands include immediate data, displacement, and extended
addresses, and contain the same timing as memory data reads.
During memory write cycles the MREQ signal goes active in the second
half of T1. At the end of T1, the data bus is driven with the write data.
At the start of T2, the WR signal is asserted Low enabling the memory.
MREQ and WR go inactive in the second half of T3 followed by
disabling of the write data on the data bus.
T2
TW
TW
T3
T1
T2
Op Code

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Z8018 Series and is the answer not in the manual?

Table of Contents