Connecting Directly To An Ethernet Network - Intermec Trakker Antares 2460 User Manual

TRAKKER Antares 246X Stationary Terminal User's Manual
2-12
5. Load and run an application. For help, see "Run Program" in Chapter 7.
Once the 2460 is installed, configured, and loaded with your C/C++ application, you
can begin using the terminal in your CrossBar network. The 2460 will run the C/C++
application and send data to the 9154 or 9161 controller. If you have existing terminals
like the 9560 or 9512, these terminals will run the equivalent IRL program and send
data to the controller.
Note: You can use COM1 to connect to another RS-232 serial device once you have
downloaded the application.

Connecting Directly to an Ethernet Network

The 2461 terminals come with an Ethernet (10BaseT) card that allows your terminal to
communicate with a host or any device on an Ethernet network.
To connect to an Ethernet network
1. Configure your host computer and network. Assign an IP address for the 2461.
2. Connect the Ethernet jack to the Ethernet connector on the back of the terminal.
246XU.012
3. Plug the other end of the Ethernet cable into an Ethernet connector on your
network.
39
nugget
Ethernet
connector
To Ethernet
network