TRAKKER Antares 246X Stationary Terminal User's Manual
Problems While Scanning Configuration Commands
You configure the terminal by scanning configuration commands. If you receive an
error beep sequence while configuring the terminal, check these possible problems and
solutions.
Problem
You receive the error beep sequence
while scanning a configuration
command.
You scan a configuration command,
such as Keypad Caps Lock, and
nothing happens.
6-8
Nugget
Solution
Check the command you are trying to scan. Make sure the command is set
correctly for the options and network communications you are using with the
terminal. For help, see Chapter 8, "Configuration Command Reference."
There are two possible solutions:
• You may have one or more reader commands disabled, such as Change
Configuration, so that you cannot change the configuration. Enable all of
the reader commands and try again.
• The terminal may be waiting for another command to complete the
configuration change. If you started by scanning the Enter Accumulate
command, you must finish the command by scanning the Exit Accumulate
command. For help, see Chapter 8, "Configuration Command Reference."
Scan the Enable Override to temporarily enable all of the reader commands.
When you are finished, remember to disable the override so that your data is
not interpreted as a command.
Enable Override
*$+DC3*
*$+DC3*
C d 39