Intermec Trakker Antares 2460 User Manual page 73

Using the Status Lights to Monitor Network Communications
You See These Lights
Network Connect status
light is turned off.
The Network Connect
status light blinks.
The Network Connect
status light remains on.
39
nugget
Status of Communications
No communications.
The 2461 is not connected to the
Ethernet network.
Partial communications.
The 2461 with UDP Plus is trying to
establish communications with the DCS
300, but it is not connected.
Note: The Network Connect status light
does not blink on a 2461 with the TCP/IP
protocol.
Normal communications. The 2461 can
communicate with the DCS 300 (UDP
Plus) or host (TCP/IP).
Operating the Terminal in a Network
What You Need to Do
You may need to enable the Network
Activate command. Make sure the terminal
is configured correctly to communicate in
your network. For help, see "Configuring
the 2461 Terminal" earlier in this chapter.
You may need to configure the terminal to
communicate with other devices in the
Ethernet network. For help, see
"Configuring the 2461 Terminal" earlier in
this chapter.
You may also need to configure the server
(UDP Plus) or host. Make sure the terminal
is configured correctly and enabled. Make
sure the server is turned on and data
collection is started.
You can send and receive data between the
terminal and the server or host.
4
4-15