Intermec Trakker Antares 2460 User Manual page 76

TRAKKER Antares 246X Stationary Terminal User's Manual
To set up the DCS 300
•
To set up the host computer
•
To set up the application
•
4-18
Configure a peer-to-peer destination name for the host application. Create a
transaction ID, $NGCFGRSP, that will be routed to this destination name. The
server uses the transaction ID to route responses from the 2461 back to the host
application. $NGCFGRSP is a special transaction ID that the server uses to forward
configuration response data from a terminal.
All configuration responses will be routed with the $NGCFGRSP transaction ID.
The server cannot keep track of multiple applications sending reader or
configuration commands. If you have two host applications sending reader or
configuration commands, they must both be configured to receive the
$NGCFGRSP transactions, and therefore both will receive all responses from all
2461 terminals.
Verify that you can communicate with the DCS 300.
Prepare and write a host application that can communicate with the server and send
transactions to and receive transactions from the 2461 in this format:
transaction header
where:
transaction header
TMF field
39
nugget
TMF field configuration command
is a 96-byte field containing the message number, date
and time, source application ID, destinations
application ID, transaction ID, and other information.
You must set the system message (SYS$MSG) flag to E
in the transaction header. For help, see the DCS 300
Technical Reference Manual.
is a 2-byte field containing one of these values:
Configuration Get request sent from the host
CG
application.
Configuration Get response sent from the 2461
Cg
to the host.
Configuration Set request sent from the host
CS
application.
Configuration Set response sent from the 2461
Cs
to the host.