Selecting Character Sets - Intermec Trakker Antares 2460 User Manual

Command: Exit Full ASCII Mode reader command
Purpose: Exits Code 39 Full ASCII mode and puts the terminal in Code 39 Non-Full ASCII mode
(one-character encoding scheme).
Syntax: -$
Scan: Exit Full ASCII
*/M/D*
*-$*

Selecting Character Sets

On the 246X terminal, you can select the character set to display on the terminal screen.
You can select the character set using either of these two commands:
•
Character Set configuration command (DX)
•
ANSI escape sequence (ESC[dataw)
The character set feature is backward compatible with the 95XX terminals and allows
you to display a subset of characters from Western European languages, such as
French, German, Italian, Portuguese, Spanish, and others. The Character Set command
(DX) is supported through the terminal firmware, but the ANSI escape sequence is only
supported through the
using the Character Set command.
Purpose: Determines the language used to display characters. The default is U.S. ASCII.
Syntax: ESC[dataw
Acceptable values for data are:
0 U.S. ASCII
1 French
2 German
3 United Kingdom
4 Danish
5 Swedish
6 Italian
7 Spanish
Note: See the Character Set (DX) command in Chapter 8 for a complete table of the
international characters.
nugget Using the Default Applications
application. See Chapter 8 for more information on
EM9560.BIN
C
C-9