Intermec Trakker Antares 2460 User Manual page 189

Nugg
Or: To set the flow control:
1. Scan this bar code:
Enter Accumulate Mode / Set Flow Control
*+/$+YL*
*+/$+YL*
2. Scan one of these bar codes to set the COM port:
COM1
*1.*
*1.*
3. Scan the flow control setting:
None
*0*
*0*
XON/XOFF Response
*2*
*2*
XON/XOFF Response and Control
*4*
*4*
4. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Notes: For COM1 only, you can use either command syntax listed next:
Syntax: YL1.data
Or: ILdata
Where data is one or two ASCII characters. For COM2, you must use the YL
configuration command.
C d 39
Configuration Command Reference
COM2
*2.*
*2.*
CTS Checking
*1*
*1*
XON/XOFF Control
*3*
*3*
CTS/RTS for DTE-DTE
*5*
*5*
8
8-41