Tcp/Ip Maximum Transmit Timeout - Intermec Trakker Antares 2460 User Manual

TRAKKER Antares 246X Stationary Terminal User's Manual
TCP Maximum Retries (continued)
3. Scan this bar code:

TCP/IP Maximum Transmit Timeout

Purpose: Defines the maximum timeout that TCP will allow between retries of a transmission in
a TCP/IP direct connect network before it gives up. For example, 20 means that the
timeout between retries is never longer than 20 seconds. Intermec has determined that
the optimum setting is 20 seconds.
Syntax: NHdata
Acceptable values for data are:
0
1-128
Default: 20 seconds
Scan: To set the default TCP/IP maximum transmit timeout, scan this bar code:
Default TCP/IP Maximum Transmit Timeout
*$+NH20*
*$+NH20*
Or: To set the TCP/IP maximum transmit timeout:
1. Scan this bar code:
2. Scan a numeric value for data from these bar codes:
8-84
Exit Accumulate Mode
*-/*
*-/*
No timeout
Transmit timeout in seconds
Enter Accumulate Mode / Set TCP/IP Maximum Transmit Timeout
*+/$+NH*
*+/$+NH*
*0*
*0*
*2*
*2*
C d 39
Nugg
*1*
*1*
*3*
*3*