Timeout Delay - Intermec Trakker Antares 2460 User Manual

Timeout Delay

Purpose: If handshaking is enabled, the terminal expects a response to each message that is sent
to the host through the serial port. The timeout delay is the amount of time the terminal
waits to receive a response. When the timeout expires, the terminal tries sending the
message again. If no response is received, a timeout error occurs.
Note: Before you enable Timeout Delay, you must configure EOM and Handshake.
Syntax: YEn.data
where n is:
1
2
Acceptable values for data are:
0
1
2
3
4
5
6
7
Default: 10 seconds
Scan: To set the default timeout delay, scan one of these bar codes:
Timeout Delay 10 sec for COM1
*$+YE1.4*
*$+YE1.4*
Timeout Delay 10 sec for COM2
*$+YE2.4*
*$+YE2.4*
Or: To set the timeout delay:
1. Scan this bar code:
C d 39
Nugg
COM1 port
COM2 port
5 ms
100 ms
500 ms
2 sec
10 sec
20 sec
40 sec
60 sec
Enter Accumulate Mode / Set Timeout Delay
*+/$+YE*
*+/$+YE*
Configuration Command Reference
8
8-89