TRAKKER Antares 246X Stationary Terminal User's Manual
Example 1
In the host application, you want to get the current values of two configuration
commands from the 2461. Send this transaction from the host application:
CG$+NABV
Note: The transaction header is not shown in this example. You do not need a
transaction header for a host application in a TCP/IP network.
where:
CG
$+
NA
BV
4-20
where:
TMF field
configuration command
is a TMF Configuration Get request.
is the Change Configuration reader command.
is the Network Activate configuration command.
is the Beep Volume configuration command.
39
nugget
is a 2-byte field containing one of these values:
Configuration Get request sent from the host
CG
application.
Configuration Get response sent from the 2461
Cg
to the host.
Configuration Set request sent from the host
CS
application.
Configuration Set response sent from the 2461
Cs
to the host.
is the reader or configuration command or commands
you want to set on the terminal, or the current value you
want to retrieve from the terminal. To save
configuration changes in flash memory, send the reader
command .+1 as the last command.
For a list of commands, see Chapter 7, "Reader
Command Reference" or Chapter 8, "Configuration
Command Reference."