TRAKKER Antares 246X Stationary Terminal User's Manual
Decode Security (continued)
Moderate Decode Security
*$+CS1*
*$+CS1*
High Decode Security
*$+CS2*
*$+CS2*
Default Router
Purpose:
Defines the IP address assigned to the default router in your Ethernet network. The
router provides a software and hardware connection between two or more networks that
permits traffic to be routed from one network to another on the basis of the intended
destinations of that traffic.
When the DCS 300 server or host (TCP/IP network) is on a different subnetwork than
the 2461 terminal, you need to set the IP address assigned to the default router. The
terminal uses the router address to send packets across the network to the server. The
default of 0.0.0.0 means there is no default router.
Syntax:
NXn.n.n.n
where each n address segment is a number from 0 to 255. The default router address
field consists of four separate numbers, each separated by a period.
Note: The Ethernet network cannot be activated if the first address segment in the IP
address is set to 0, 127, or a number greater than 223.
Default:
0.0.0.0
Scan:
To set the default value for the default router, scan this bar code:
Default Router
*$+NX0.0.0.0*
*$+NX0.0.0.0*
8-34
C d 39
Nugg