Configuration Commands Via Serial Port - Intermec Trakker Antares 2460 User Manual

TRAKKER Antares 246X Stationary Terminal User's Manual
Command Processing (continued)
Or: To disable or enable the ability to scan multiple-read labels, scan one of these bar
codes:
Disable Multiple-Read Labels
*$+DC 0*
*$+DC 0*

Configuration Commands Via Serial Port

Purpose: Allows you to control the data the terminal receives through the serial port. You can set
this command to execute reader and configuration commands received through the
serial port, or treat all data as data without checking for special command syntax. There
are three options:
Disabled All data received through the serial port is treated as data. The terminal will
not execute reader or configuration commands sent or encoded in the data.
Enabled with TMF If the data is sent with the TMF (Terminal Message Format)
header, the terminal will check for and execute the TMF command received through the
serial port. With TMF, you can execute reader and configuration commands, or send
and receive data about the current terminal configuration.
Enabled without TMF The terminal will check for and execute all reader and
configuration commands (i.e., Receive File reader command or Beep Volume change
configuration command).
Note: Before you can enable Configuration Commands Via Serial Port with or without
TMF, you must configure the EOM command.
Syntax: YTn.data
where n is:
1
2
Acceptable values for data are:
0
1
2
Default: Enabled without TMF
8-28
COM1 port
COM2 port
Disabled
Enabled with TMF
Enabled without TMF
C d 39
Nugg
Enable Multiple-Read Labels
*$+DC 1*
*$+DC 1*