Append Time; Automatic Shutoff - Intermec Trakker Antares 2460 User Manual

Append Time

Purpose: Appends the time to bar code labels when they are scanned into the terminal. You can
also use the Time in Seconds command to append the time in hours and minutes only,
or hours, minutes, and seconds. The time is appended to the data in the form
HH:MM:SS. For help, see "Time in Seconds" later in this chapter.
Syntax: DEdata
Acceptable values for data are:
0
1
Default: Disabled
Scan: One of these bar codes:
Disable Append Time
*$+DE0*
*$+DE0*
Enable Append Time
*$+DE1*
*$+DE1*

Automatic Shutoff

Purpose: Defines the maximum length of time the terminal remains on when there is no activity.
When you do not use the terminal for the length of time set with this command, the
terminal automatically turns off as if you had pressed
When you press
was when you turned it off or the terminal boots and restarts your application. Resume
is controlled through the Resume Execution command. For help, see "Resume
Execution" later in this chapter.
Syntax: EZdata
Acceptable values for data are:
0
02-75
C d 39
Nugg
Disabled
Enabled
9
to turn on the terminal, the terminal either resumes exactly where it
Disabled (always on)
Shutoff time in minutes
Configuration Command Reference
9
to turn it off.
8
8-7