Intermec Trakker Antares 2460 User Manual page 177

Nugg
Scan: To set the default configuration, scan one of these bar codes:
Default Configuration for COM1
*$+YT1.2*
*$+YT1.2*
Default Configuration for COM2
*$+YT2.2*
*$+YT2.2*
Or: To set the configuration commands:
1. Scan this bar code:
Enter Accumulate Mode / Set Configuration Commands Via Serial Port
*+/$+YT*
*+/$+YT*
2. Scan one of these bar codes to set the COM port:
COM1
*1.*
*1.*
3. Scan the configuration command:
Disabled
*0*
*0*
Enabled Without TMF
*2*
*2*
4. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
5. Repeat Steps 1 through 4 to set the configuration commands via serial port for
another serial port.
C d 39
Configuration Command Reference
COM2
*2.*
*2.*
Enabled With TMF
*1*
*1*
8
8-29