Intermec Trakker Antares 2460 User Manual page 136

TRAKKER Antares 246X Stationary Terminal User's Manual
Receive File Through the Serial Port (continued)
From Network:
.%X n , drive:filename
.%K n,drive:filename
.%Y n,drive:filename
.%Y n , drive:
where:
.%X
.%K
.%Y
n
drive:
filename
Keypad: Not supported
Note: To scan these bar code labels, you must configure the terminal to use Code 39 in
Full ASCII mode. For help, see "Code 39" in Chapter 8.
Scan: 1. Scan this bar code label:
2. Scan the bar code label for the communications protocol you want to use.
3. Scan the bar code label for the terminal COM port you are using to receive the file.
4. Scan the bar code label(s) for the file you want to receive. You can scan labels from
7-16
is the command to receive a file using
is the command to receive a file using
is the command to receive a file using
indicates the terminal's serial port: 1 or 2.
indicates the drive on the terminal where you want to receive and
store the file. You must include the colon (:) after the drive letter.
is the file you want to receive and save on the terminal.
Enter Accumulate Mode / Receive File
*/K/O./E*
*+/.%*
XMODEM
*X*
*X*
The label also includes the required comma.
COM1
*1/L*
*1,*
the "Full ASCII Bar Code Chart" in Appendix B. The label must use this format:
drive:filename
39
nugget
Receives a file using
Receives a file using
Receives a file using
Receives a batch of files using
XMODEM
XMODEM-1K
YMODEM
XMODEM-1K
*K*
*K*
COM2 (2460 only)
*2/L*
*2,*
protocol
XMODEM
protocol
XMODEM-1K
protocol
YMODEM
YMODEM
protocol.
protocol.
protocol.
YMODEM
*Y*
*Y*