Baud Rate
Purpose:
Sets the baud rate for the serial port(s) on the terminal. The baud rate must match the
baud rate of the device (i.e., the host computer) that the terminal is communicating with
through the serial port.
Syntax:
YAn.data
where n is:
1
2
Acceptable values for data are:
3
4
5
6
7
8
Default:
19200
To set the default baud rate, scan one of these bar codes:
Scan:
Default Baud Rate for COM1
*$+YA1.7*
*$+YA1.7*
Default Baud Rate for COM2
*$+YA2.7*
*$+YA2.7*
Or:
To set the baud rate:
1. Scan this bar code:
C d 39
Nugg
COM1 serial port
COM2 serial port
1200 baud
2400 baud
4800 baud
9600 baud
19200 baud
38400 baud
Enter Accumulate Mode/Set Baud Rate
*+/$+YA*
*+/$+YA*
Configuration Command Reference
8
8-9