Intermec Trakker Antares 2460 User Manual page 87

The 246X stationary terminals use these protocols:
Layer
Physical
Data Link
Network
Transport
Session and Presentation
Presentation and Application
39
nugget
Protocol Description
Ethernet card Provides Ethernet communications.
Serial port Provides RS-232 serial communications.
Ethernet protocol Provides Ethernet media access control. The default hardwired
driver media access control (MAC) protocol used with TCP/IP
supports the Ethernet II standard.
Serial port driver Provides RS-232 (COM1) or RS-232/422/485 (COM2) serial
communications control that uses CSP and the standard
XMODEM or YMODEM protocol for data transfer.
IP, ARP, and ICMP The Internet Protocol (IP) complies with the standard outlined
in RFC 791.
The Address Resolution Protocol (ARP) complies with the
standard outlined in RFC 826.
The Internet Control Message Protocol (ICMP) complies with
the standard outlined in RFC 826.
UDP The User Datagram Protocol (UDP) complies with the
standard outlined in RFC 768.
TCP Transmission Control Protocol (TCP) complies with the
standard outlined in RFC 793.
UDP Plus UDP Plus is an Intermec proprietary session layer protocol
built on UDP. The UDP Plus session layer provides these
services:
• guaranteed delivery
• duplicated message removal
• link connection and status management
• network error recovery
• congestion control
• device error detection
TFTP Trivial File Transfer Protocol (TFTP) allows efficient file
exchange between the terminal and the DCS 300 or host.
TFTP complies with the standard outlined in RFC 1350.
TMF Terminal Message Format is an Intermec proprietary protocol
that is used to route data, configuration, and network
management messages between applications on the terminal
and peer tasks on the server or host.
Operating the Terminal in a Network
4
4-29