Entering Variable Data In A Configuration Command - Intermec Trakker Antares 2460 User Manual

TRAKKER Antares 246X Stationary Terminal User's Manual

Entering Variable Data in a Configuration Command

You can enter variable data for many of the configuration commands. For example, you
can set a preamble that is up to 25 ASCII characters long. You need to follow these
general instructions to enter variable data.
To enter variable data in a configuration command
1. Scan a bar code label with this syntax:
2. Scan a bar code label from the "Full ASCII Bar Code Chart" in Appendix B. To set
3. Scan the Exit Accumulate Mode bar code label to update the terminal's
8-6
+/$+ command
where:
+/ is the syntax for the Enter Accumulate Mode command.
$+ is the syntax for the Change Configuration command.
command is the syntax for the command you want to change.
For example, the command syntax for a preamble is ADdata. To change or set a
preamble, scan this bar code:
Enter Accumulate Mode / Change Configuration / Set Preamble
*+/$+AD*
*+/$+AD*
the preamble to the character T, scan this label:
T
*T*
*T*
Note: To use the bar code labels in Appendix B, you must configure the terminal to
use Code 39 in Full ASCII mode. For help, see "Code 39" later in this chapter.
configuration:
Exit Accumulate Mode
*-/*
*-/*
C d 39
Nugg