Intermec Trakker Antares 2460 User Manual page 38

TRAKKER Antares 246X Stationary Terminal User's Manual
Equipment you need to install the 2460 in a CrossBar network
Make sure you have this equipment before you begin:
•
•
To install the TRAKKER Antares CrossBar adapter
1. On the 9154 or 9161 controller, disconnect the Multi-Drop network cable.
2. Connect the Multi-Drop network cable to one end of the TRAKKER Antares
3. Connect the other end of the TRAKKER Antares CrossBar adapter to the 9154 or
To 2460
Drop cable
or 95XX
terminal
Connect to
next drop
cable
To install the 2460 in an existing CrossBar network
1. Insert the 25-pin multi-drop connector of the Drop cable (Part No. 047653) into the
2. Use a small straight-slot screwdriver to tighten the two screws in the multi-drop
2-10
One Multi-Drop (or Drop) cable (Part No. 047653) for each 2460 terminal
One TRAKKER Antares CrossBar adapter (Part No. 069447) for each 9154 or
9161 controller
CrossBar adapter.
9161 controller.
To 2460
or 95XX
Drop cable
terminal
Trunk cable
COM2 port on the back of the terminal.
connector.
39
nugget
TRAKKER Antares
CrossBar adapter
246XU.031
Trunk cable
To 9154 or 9161
controller port