Lrc (Longitudinal Redundancy Check) - Intermec Trakker Antares 2460 User Manual

TRAKKER Antares 246X Stationary Terminal User's Manual

LRC (Longitudinal Redundancy Check)

Purpose: The Longitudinal Redundancy Check (LRC) character is an error-checking character
that you can append to transmitted and received blocks of data.
Note: Before you can enable LRC, you must configure the EOM command.
Syntax: YFn.data
where n is:
1
2
Acceptable values for data are:
0
1
Default: Disabled
Scan: To disable LRC, scan one of these bar codes:
Disable LRC for COM1
*$+YF1.0*
*$+YF1.0*
Disable LRC for COM2
*$+YF2.0*
*$+YF2.0*
Or: To enable LRC, scan one of these bar codes:
Enable LRC for COM1
*$+YF1.1*
*$+YF1.1*
Enable LRC for COM2
*$+YF2.1*
*$+YF2.1*
Notes: For COM1 only, you can use either command syntax listed next:
Syntax:
Or:
Where data is a value of 0 or 1. For COM2, you must use the YF configuration
command.
8-54
COM1 port
COM2 port
LRC disabled
LRC enabled
YF1.data
IFdata
C d 39
Nugg