Inserting The 243X In The Vehicle Dock; Connecting To Power, Serial Devices, And Scanners; Connecting To A Power Supply - Intermec Trakker Antares 2430 Accessories Manual

Inserting the 243X in the Vehicle Dock

1. Pull the release for the retaining bracket.
2. Lower the retaining bracket.
3. Slide the 243X into the vehicle dock as shown in the previous
illustration. Make sure that the 243X is firmly seated in the dock.
4. Push the retaining bracket toward the top of the 243X. The retaining
bracket produces one or two audible "clicks" when it snaps into
place.
8
3
2
1
2435AI005.eps
4
2435AI007.eps
To remove the 243X from the vehicle dock
1. Pull the release for the retaining bracket.
2. Lower the retaining bracket.
3. Slide the 243X out of the vehicle dock.
Connecting to Power, Serial Devices, and
Scanners
If you are installing the powered vehicle dock, you can connect to a
power supply, a scanner, and a serial device such as a printer.
Power supply
connector

Connecting to a Power Supply

The powered vehicle dock can be connected to either a DC or AC power
supply. The power supply accessories are sold separately.
For a vehicle installation, you need one of these DC power supply kits
(sold separately):
•
Low-input voltage kit (6 to 36 VDC) (Part No. 070833)
•
High-input voltage kit (15 to 96 VDC) (Part No. 070834)
Serial
connector
Scanner
connector
2435AI004.eps
9