TRAKKER Antares 246X Stationary Terminal User's Manual
Handshake
Purpose:
Enables or disables the handshake event that is an affirmative acknowledge to a
message received through the serial port.
Note: Before you can enable Handshake, you must configure the EOM command.
Handshake is also referred to as AFF (affirmative acknowledge) on other Intermec
data collection devices.
Syntax:
YJn.data
where n is:
1
2
Acceptable values for data are:
Disabled
Enabled
Default:
Disabled
Scan:
To disable handshake, scan one of these bar codes:
Disable Handshake for COM1
*$+YJ1.*
*$+YJ1.*
Disable Handshake for COM2
*$+YJ2.*
*$+YJ2.*
Or:
To enable handshake, scan one of these bar codes:
Note: To scan the following bar codes, you must configure the terminal to use Code 39
in Full ASCII mode. For help, see "Code 39" earlier in this chapter.
Enable Handshake (Set to ACK) for COM1
*/D/KYJ1.$F*
*$+YJ1.$F*
Enable Handshake (Set to ACK) for COM2
*/DE/KYJ2.$F*
*$+YJ2.$F*
8-42
COM1 port
COM2 port
No ACK or NAK transmitted
Set to ACK (Acknowledge, hexadecimal value \x06)
C d 39
Nugg