Configuring The 2461 Over The Network; Configuring The 2461 From The Dcs 300 - Intermec Trakker Antares 2460 User Manual

TRAKKER Antares 246X Stationary Terminal User's Manual

Configuring the 2461 Over the Network

You can remotely configure a 2461 terminal by using one of these methods:
•
•
Once the terminal is communicating, you can configure bar code symbologies and send
operating commands. You cannot configure any of the Ethernet network parameters,
such as terminal IP address, over the network.
Note: You can configure the terminal locally by scanning a command from a Code 39
or Code 93 bar code label. For help, see Chapter 3, "Configuring the Terminal."

Configuring the 2461 From the DCS 300

If your terminal is configured for UDP Plus, you can use the DCS 300 to configure one
or more 2461 terminals in your Ethernet network. You can also send reader commands
such as Delete File to one or more terminals.
This method is very fast and efficient if you need to change the same configuration
parameters for several terminals in one area. For example, you may want to set the
Beep Volume to very loud for all the terminals in one area.
Note: You can configure a 2461 from the DCS 300, but you cannot get configuration
data from the terminal.
To send commands from the DCS 300
1. Using the Download Server feature on the DCS 300, select the terminal or group to
2. Choose the Command option button.
3. Enter the reader or configuration command and choose Add. The command appears
4-16
Send a command from the DCS 300 (UDP Plus network only).
Send a command from an application on the host computer.
which you want to download the configuration commands. For help on configuring
a group of terminals, see the DCS 300 System Manual.
Note: You can continue running an application on the 2461 while configuring the
terminal from the DCS 300.
in the Files and Data box.
39
nugget