Set Time And Date - Intermec Trakker Antares 2460 User Manual

Purpose: The Scanner Trigger Off command is the same as releasing the trigger on the 1545 laser
scanner. Its effect depends on the Scanner mode and Scanner Trigger mode
configuration settings as described earlier.
From Network:
/%
Scan: Not supported

Set Time and Date

Purpose: Sets the time and date on the terminal. When the terminal receives the time broadcast
command from the 9154 or 9161 controller, the command sets the clock on the
terminal. You can configure the clock with or without seconds.
Use this command only for backward compatibility with the 95XX terminal. If you do
not need backward compatibility, use the Time and Date configuration command. For
help, see "Time and Date" in Chapter 8.
Note: The Set Time and Date command was called Enable Clock for the 95XX
terminals.
From Network:
/+ data
Acceptable formats for data to set the time and date are:
yy/mm/dd:hh:mm:ss
yy/mm/dd:hh:mm
hh:mm:ss
hh:mm
Values for yy that range from 00 to 95 are interpreted as 2000 through 2095. Values for
yy that range from 96 to 99 are interpreted as 1996 through 1999.
Keyboard: Not supported.
Label Syntax: You can create your own bar code labels to set the time and date by creating a bar code
in this command format:
/+ data
where data is one of the formats listed above.
39
nugget Reader Command Reference
7
7-11