Intermec Trakker Antares 2460 User Manual page 285

error messages
DCS 300, 6-10
POST failed, 6-5
Ethernet
configuration commands, listed, A-10
connecting, 2-12
connector, 1-5
network, illustrated, 4-12
parameters, 2-17
specifications, A-4
troubleshooting, 6-6
European Article Numbering, See UPC/EAN command
examples
2461, remotely configuring, 4-20, 4-21, 4-24
serial port, remotely configuring the terminal, 4-11
EXE2ABS.EXE program, using, 5-8
Exit Accumulate mode
configuration commands, using, 8-6
reader command, using, 7-6
exiting applications, 7-14
extended memory, specifications, A-4
EZBuilder
applications, developing, 5-7
binary files, converting, 5-8
F
file management, using reader commands, 7-13
file system, specifications, 5-5
FileCopy utility, using, 5-9
files
converting 7-bit to 8-bit, 7-17, 7-25
deleting, 7-14
renaming, 7-21
transmitting, 7-15, 7-23
RF communications, using, 4-22
serial port, using, 5-9
firmware
applications, restarting, 6-14, 7-9
upgrading, 3-10
flash memory
default configuration, saving, 7-8
described, 1-9
saving changes, 3-9
saving configuration changes, 3-9, 7-10
specifications, A-4
Flash Memory Configuration, configuration command,
8-39
Flow Control command, 8-40
Frame mode
described, 4-8, 8-37
troubleshooting, 6-7
full ASCII
bar code chart of characters, B-6 to B-10
Code 39, described, 8-19
table of characters, B-3 to B-5
Full ASCII mode for Code 39, configuring with
EM9560.BIN, C-8
Function Code 1
Code 128, using with, 8-24
Code 16K, enable with, 8-16
Code 49, enable with, 8-22
Function Code 2, Code 49, 8-22
Function Code 3, Code 49, 8-22
G, H
Good Read status light, described, 1-6
Handshake command, 8-42
Health Industry Bar Code, See HIBC, Code 39
hexadecimal, table of ASCII characters, B-3 to B-5
HIBC, Code 39, 8-20
host application
transferring data, 4-9
host computer
not receiving data, troubleshooting, 6-9
serial port, using to configure, 4-9
transmitting files, 4-22, 7-19, 7-27
Host IP Address command, 8-43
host, using to configure the 2461, 4-17
humidity, operating and storage range, A-3
I
ICMP, defined, 4-29
input devices
configuring for scan module, 8-73
connecting, 2-6
list for scanner connector, A-5
troubleshooting, 6-11 to 6-12
installing
2.4 GHz RF network, overview, 4-12
DCS 300, 4-13
necessary equipment, 2-3
network, overview, 4-3, 4-12
terminal, 2-3
Interactive Reader Language, See IRL
interface cable, connecting to scan module, 6-11
Interleaved 2 of 5
configuration command, 8-45
Interleaved 2 of 5 command
disabled with Code 2 of 5, 8-17
Intermec support services, xiii
IRL programs, converting, 5-7
ISBT Code 128, configuration command, 8-47
I
Index
I-7