(2435 Only) Configure The Network Parameters - Intermec Trakker Antares 2430 Quick Start Manual

C d 39 nuggetfont
SERIAL PORT [COM1]
Protocol:
Configurable
Baud Rate: 19200
Parity: Even
Data Bits: 7
Stop Bits: 1
` more
243XQ156.eps
Serial Port [COM1] Menu

(2435 Only) Configure the Network Parameters

Before you can use the 2435, you need to install and configure
the host and access points. You may also need to install and
configure the Intermec Gateway or DCS 30X. Depending on
your network protocol, the 2435 can communicate with a host
computer either through access points and the Intermec
Gateway or DCS 30X (UDP Plus or WTP network) or directly
through the access points (TCP/IP network).
Press l t 2 4 8 , l x 2 4 8 , or the
orange > key and then * 2 4 8 to access the TRAKKER
Antares 2400 Menu System. Choose Configuration Menu,
Communications Menu, Primary Network or Advanced
Network. You need to obtain most of these settings from your
network administrator.
Note: If you are using the WTP network, you only
need to configure the Primary Network parameters.
To configure the Primary Network parameters
1 Make sure that 2.4 GHz RF (OpenAir radio) or 802.11 DS
(802.11b radio) appears in the Activate field.
If you are using the WTP network, you only need to
configure the Activate field.
2 (UDP Plus) In the Controller IP Address field, enter the IP
address of the Intermec Gateway or DCS 30X. The IP
12 Trakker Antares 243X Handheld Terminal Quick Start Guide