End of Message (EOM)
Purpose:
Attaches an EOM to the end of a data block to indicate the end of data transmission to
and from a terminal. When EOM is disabled, the terminal communicates in Character
mode. When EOM is enabled, the terminal communicates in Frame mode.
You must configure a value for EOM before you can set these other serial
communications commands:
•
•
•
•
EOM cannot equal the same value that is set for SOM. You cannot set EOM to any of
these values:
•
•
•
•
•
Syntax:
YZn.data
where n is:
1
2
Acceptable values for data are one or two ASCII characters.
Default:
\x03 (hexadecimal value for ETX)
Scan:
To disable EOM for each serial port, scan one of these bar codes:
Disable EOM for COM1
*$+YZ1.*
*$+YZ1.*
Disable EOM for COM2
*$+YZ2.*
*$+YZ2.*
C d 39
Nugg
Configuration Commands Via Serial Port
Handshake
LRC
Start of Message (SOM)
AFF (ACK)
DLE
NEG (NAK)
Poll
RES (EOT)
COM1 port
COM2 port
Configuration Command Reference
•
REQ (ENQ)
•
SEL
•
XOFF
•
XON
8
8-37