Problems Transmitting Data Through The Dcs 300 - Intermec Trakker Antares 2460 User Manual

TRAKKER Antares 246X Stationary Terminal User's Manual

Problems Transmitting Data Through the DCS 300

If you have a problem while running the application on the 2461 terminal in a UDP
Plus network, check these possible communications problems.
Problem
Transaction Buffer Full.
Sending Buffer Transactions.
Transaction Aborted.
Transmit Error XX, press Enter.
Receive Error XX, press Enter.
Shutting down.
Controller Shutdown.
6-10
Nugget
Solution
The buffer holding transactions to be sent to the controller is full. Stop
collecting data with this terminal. Make sure the terminal is
communicating with the DCS 300 and let the terminal send all the
transactions in the buffer before you continue collecting data.
This is an information message to tell you that buffered transactions are
now being sent to the DCS 300. You can begin collecting data again
once the message clears.
The transaction just sent to the DCS 300 was not received. Try sending
the transaction again.
There is an error transmitting data to the DCS 300. XX represents the
status code error. Note the error code listed in the message and contact
your local Intermec service representative for help. Press
continue.
There is an error receiving data from the DCS 300. XX represents the
status code error. Note the error code listed in the message and contact
your local Intermec service representative for help. Press
continue.
The DCS 300 is shutting down. You may continue collecting data and
buffer the transactions in the terminal until the DCS 300 starts again, or
stop collecting data with the terminal.
The DCS 300 has shut down. You may continue collecting data and
buffer the transactions in the terminal until the DCS 300 starts again, or
stop collecting data with the terminal.
C d 39
9
9
to
to