Setting Preambles And Postambles - Intermec Trakker Antares 2460 User Manual

TRAKKER Antares 246X Stationary Terminal User's Manual
Using Display Control Codes (continued)
Command
Save Cursor
Position
Select Character Set

Setting Preambles and Postambles

With the
C on the TRAKKER Antares terminal and make the terminal compatible with the
95XX terminals. The preambles are prepended and the postamble is appended to the
data that is transmitted through all the serial ports.
Preamble A, Preamble B, and Postamble C can each be up to 25 ASCII characters in
length. If you enter a preamble or postamble command without entering data, the
preamble or postamble buffer is cleared.
Syntax: Preamble A
Preamble B
Postamble C
Scan: To set the preamble or postamble using the AA, AB, or AC configuration commands:
1. Scan one of these bar code labels:
2. Scan a value for data from the "Full ASCII Bar Code Chart" in Appendix B. The
C-6
Control Code
ESC[s
ESC[ n w
application, you can set Preamble A, Preamble B, and Postamble
EM9560.BIN
AAdata or +.data
ABdata or ++data
ACdata or +%data
Enter Accumulate Mode / Set Preamble A
*+/$+AA*
*+/$+AA*
Enter Accumulate Mode / Set Preamble B
*+/$+AB*
*+/$+AB*
Enter Accumulate Mode / Set Postamble C
*+/$+AC*
*+/$+AC*
preamble or postamble can be from 1 to 25 characters.
nugget
Description or Action
Saves the current cursor position. Successive
Save Cursor Position commands overwrite the
previous position that was saved.
Defines the character set to be used where n
identifies the character set. For help, see
"Selecting Character Sets" later in this
appendix.