Transmit File Via Network Communications - Intermec Trakker Antares 2460 User Manual

Transmit File Via Network Communications

Purpose: Transmits a file from the 2461 terminal and saves it on the DCS 300 or host.
From Network:
%%R, drive:fromfilename,tofilename
where:
%%R
drive:
fromfilename
tofilename
Not supported
Keypad:
Note: To scan these bar code labels, you must configure the terminal to use Code 39 in
Full ASCII mode. For help, see "Code 39" in Chapter 8.
Scan: 1. Scan this bar code label:
2. Scan the bar code label(s) for the file you want to transmit. You can scan labels
3. Scan this bar code label to exit Accumulate mode and transmit the file.
nugget
is the command to transmit a file over the Ethernet network from the
2461 terminal to the DCS 300 or host.
indicates the drive where the file is stored on the 2461 terminal. You
must include the colon (:) after the drive letter.
is the name of the file you are transmitting from the 2461 terminal to
the DCS 300 or host.
is the name of the file that will be saved on the DCS 300 or host. On
the DCS 300, the file is saved on the
transmit a file to the host, you need to identify the path and filename
where you want to save the file.
Note: Do not specify the pathname
field.
Enter Accumulate Mode / Transmit File
*/K/O/E/ER/L*
*+/%%R,*
from the "Full ASCII Bar Code Chart" in Appendix B. The label must use this
format:
drive:fromfilename,tofilename
Exit Accumulate Mode
*-/*
*-/*
39
Reader Command Reference
D:\USERDATA
D:\USERDATA
7
directory. To
in the tofilename
7-27