Intermec Trakker Antares 2460 User Manual page 146

TRAKKER Antares 246X Stationary Terminal User's Manual
Transmit and Convert 8-Bit Binary Files to 7-Bit ASCII Files (continued)
Scan: 1. Scan this bar code label:
Note: To scan these bar code labels, you must configure the terminal to use Code 39 in
Full ASCII mode. For help, see "Code 39" in Chapter 8.
2. Scan the bar code label for the terminal COM port you are using to transmit the
3. Scan the bar code label(s) for the file you want to transmit. You can scan labels
4. Scan this bar code label to exit Accumulate mode and transmit the file.
Or: You can create your own bar code labels to transmit files by creating a bar code in this
command format:
%%H n , drive:filename
Example: You want to upload an application from the 246X terminal in your CrossBar network to
the host. On the host, you need to receive the file using a utility such as InterScan.
Enter this command to transmit the file
through COM2:
%%H2,c:shipping.bin
The file is converted from 8-bit binary to 7-bit ASCII hexadecimal and transmitted to
the host. Use
format.
7-26
Enter Accumulate Mode / Transmit File
*/K/O/E/EH*
*+/%%H*
file. The label also includes the required comma.
COM1
*1/L*
*1,*
from the "Full ASCII Bar Code Chart" in Appendix B. The label must use this
format:
drive:filename
Exit Accumulate Mode
*-/*
*-/*
to convert the application back to its original 8-bit binary
HEX.EXE
39
nugget
COM2
*2/L*
*2,*
from the terminal's drive C
SHIPPING.BIN