Or:
To set the multi-drop address:
1. Scan this bar code:
2. Scan a value for data from the "Full ASCII Bar Code Chart" in Appendix B. The
3. Scan this bar code:
Network Activate
Purpose:
Enables or disables network communications between the 2461 terminal and other
devices in the Ethernet network. When you enable this parameter, the terminal attempts
to establish communications with the DCS 300 server or host computer. When you
disable this parameter, the network is disabled.
Note: You must enable the Network Activate parameter to use the 2461 for data
collection in your Ethernet network.
Syntax:
NAdata
Acceptable values for data are:
0
1
Default:
Disabled
Scan:
One of these bar codes:
Disable Network Activate
*$+NA0*
*$+NA0*
Enable Ethernet Network
*$+NA1*
*$+NA1*
C d 39
Nugg
Enter Accumulate Mode / Set Multi-Drop Address
*+/$+YN2.*
*+/$+YN2.*
address is a single alphanumeric character from A through Z or 0 to 5.
Exit Accumulate Mode
*-/*
*-/*
Disabled
Ethernet network (enabled)
Configuration Command Reference
8
8-57