Operating Reader Commands; Boot Terminal - Intermec Trakker Antares 2460 User Manual

Operating Reader Commands

The reader commands you can use to operate or change the terminal's configuration are
listed in this section. The operating commands are listed in alphabetical order. You will
find these reader commands detailed in this section:
•
•
•
•
•
•
•
•
•

Boot Terminal

Purpose: Boots the terminal. The terminal runs through power-on self test (POST) to test each
major subsystem. The terminal uses the configuration currently saved in flash memory
to boot and then your application appears on the screen.
Use this command when you upgrade the firmware on the terminal or if your terminal
locks up and will not respond.
From Network:
-.1
Scan: Boot Terminal
*-.1*
*-.1*
nugget
Boot Terminal
Change Configuration
Default Configuration
Multiple-Read Labels
Reset Firmware
Save Configuration in Flash Memory
Scanner Trigger On and Off
Set Time and Date
Status Lights Control
39
Reader Command Reference
7
7-7