Receive File Via Network Communications - Intermec Trakker Antares 2460 User Manual

4. Scan this bar code label to exit Accumulate mode and receive the file.
Or: You can create your own bar code labels to receive files by creating a bar code in this
command format:
.%H n , drive:filename
Example: You want to send an application from the host in your CrossBar network to the 246X
terminal. On the host, use
SHIPPING.HEX
through the 9154 or 9161 to the 246X terminal. Enter this command to receive the file
SHIPPING.BIN
.%H2,c:shipping.bin
The file
binary, and stored as

Receive File Via Network Communications

Purpose: Receives a file from the DCS 300 or host and saves it on the 2461 terminal.
From Network:
.%R, fromfilename,drive:tofilename
where:
.%R
fromfilename
drive:
tofilename
Keypad: Not supported
Note: To scan these bar code labels, you must configure the terminal to use Code 39 in
Full ASCII mode. For help, see "Code 39" in Chapter 8.
nugget
Exit Accumulate Mode
*-/*
*-/*
HEX.EXE
. On the host, use a utility such as InterScan to transmit
on the terminal's drive C through COM2:
is transferred, converted from 7-bit ASCII hexadecimal to 8-bit
SHIPPING.HEX
SHIPPING.BIN
is the command to receive a file that is transmitted over the Ethernet
network to the 2461 terminal.
is the name of the file you are transmitting from the DCS 300 or host
to the 2461 terminal. On the DCS 300, the file must be sent from the
D:\USERDATA
identify the path and filename.
Note: Do not specify the DCS 300 pathname
fromfilename field.
indicates the drive on the 2461 terminal where you want to receive
and store the file. You must include the colon (:) after the drive letter.
is the name of the file you want to save on the 2461 terminal.
39
Reader Command Reference
to convert the application from
on the 246X terminal.
directory. To receive a file from the host, you need to
7
to
SHIPPING.BIN
SHIPPING.HEX
in the
D:\USERDATA
7-19