Network Port - Intermec Trakker Antares 2460 User Manual

TRAKKER Antares 246X Stationary Terminal User's Manual

Network Port

Purpose: Defines the network port that the TCP/IP or UDP Plus network protocol uses for
communications in your Ethernet network. In a TCP/IP network, set the network port to
the appropriate port for the application you are using on the 2461 terminal In a UDP
Plus network, the network port you set on the 2461 must match the network port that is
set on the DCS 300 server.
Syntax: NGdata
Acceptable values for data are any number from 1 to 65535.
Default: 00023
05555
Scan: To set the default network port for a 2461 with TCP/IP, scan this bar code:
Default TCP/IP Network Port
*$+NG23*
*$+NG23*
To set the default network port for a 2461 with UDP Plus, scan this bar code:
Default UDP Plus Network Port
*$+NG5555*
*$+NG5555*
Or: To set the network port:
1. Scan this bar code:
8-58
2461 with TCP/IP network protocol
2461 with UDP Plus network protocol
Enter Accumulate Mode / Set Network Port
*+/$+NG*
*+/$+NG*
C d 39
Nugg