Troubleshooting Applications - Intermec Trakker Antares 2460 User Manual

If you downloaded the command to run an application, the terminal boots, resets, and
runs the application.
For help running an application, see "Run Program" in Chapter 7. If you have problems
downloading files, see Chapter 6, "Troubleshooting."

Troubleshooting Applications

Once you download a new application to the terminal, you are ready to test it before
you start collecting data. If the terminal or application appears to be locked up and you
cannot enter data, try these steps in order.
To troubleshoot a locked-up terminal or application
1. Press
2. Scan the Reset Firmware label to restart the firmware and application.
3. Scan a bar code to configure the Resume Execution command to resume "not
4. If your terminal appears to boot but the application will not run or is locked up,
5. If the terminal will not turn off or does not respond to the Reset Firmware
nugget
9
to turn off the terminal. If it turns off, press
You can continue working.
Reset Firmware
*-.*
*-.*
You can also send the Reset Firmware command over the network. For help, see
Chapter 7, "Reader Command Reference."
9
allowed." See the "Resume Execution" command in Chapter 8. Each time you press
to turn on the terminal, the terminal boots and restarts your application.
9
press and hold the Tab key immediately after you scan the Reset Firmware label or
after you press to turn on the terminal. Continue to hold the Tab until you hear a
click and the screen clears.
The terminal has booted without loading an application. Load and run another
application or download a new version of the application before you run it again.
command, boot the terminal. Make sure you have tried Steps 1 and 2 before you
boot the terminal.
9
a. Press to turn off the terminal. If it will not turn off, continue with the next
step.
b. Scan this bar code:
Boot Terminal
*-.1*
*-.1*
39
Programming the Terminal
9
to turn on the terminal.
5
5-17