TRAKKER Antares 246X Stationary Terminal User's Manual
Command Processing (continued)
Or:
To disable or enable specific reader commands, perform these steps:
1. Scan this bar code:
2. Scan the bar code to disable or enable one reader command.
8-26
Enter Accumulate Mode / Command Processing
*+/$+DC*
*+/$+DC*
Note: If there are two bar codes for a reader command, you must scan them in
order, left to right. Accumulate mode commands are separated into two bar codes
so that the command can be accumulated rather than executed as a command.
Abort Program
*/$*
*/$*
Backspace
*-*
*-*
Boot Terminal
*-.1*
*-.*
Clear
*-*
*-*
Default/Save Configuration
*.+*
*.+*
Enter Accumulate Mode
*+*
*+*
Exit Accumulate Mode
*-*
*-*
C d 39
Nugg
(continued)
*+*
*+*
Change Configuration
*$+*
*$+*
(continued)
*-*
*-*
Delete File
*..--*
*..--*
(continued)
*/*
*/*
(continued)
*/*
*/*